Oven hook up electrical How to Connect the Power Cord for an Electric Range

Oven hook up electrical

Most ranges are fed by a amp or amp circuit and connect to a wall catholic dating rules receptacle with a 3-prong or 4-prong cord, depending on the type of receptacle. If necessary, alter the ground-to-neutral connection as needed, depending on the type of There may be a hole about 1" in diameter in or near the cover; this is for the cord to pass through.

Speed dating montpellier 2015

Or, you may be able to fold the strap in half so that both of its holes fit onto the neutral terminal. Reinstall the screws and tighten the clamp Tighten all of the screws firmly. Continue to 7 of 7 below.

Label dating provider

If there is a ground screw and it is connected to the neutral center terminal with a metal strap or short wire, remove the strap or wire from the ground screw and the neutral terminal. MORE only three wiring terminals for the cord: Remove the Wire Connection Cover Plate Locate the removable metal cover plate or shroud on the back panel of the range. Attach the left cord wire to the left hot terminal, and attach the right cord wire to the right hot terminal. You may want to squeeze the two halves together gently with pliers while installing the screws.

Online dating message pua

Keep the strap or wire in a safe place in case you need to convert back to a 3-prong cord in the future. Remove the screws holding the clamp halves together.

Remove the screws or bolts securing the oven hook up electrical, using a screwdriver or nut driver, and remove the cover from the range. There are three terminals in a line: Continue to 5 of 7 below. Consult your owner's manual or the range manufacturer for specific wiring requirements.

Global offensive matchmaking down

Install the Strain-Relief Clamp Install a strain-relief clamp to secure the cord to the back of the range. Never plug a oven hook up electrical cord into a range receptacle to see if it fits.

Continue to 2 of 7 below. An electric range is a freestanding unit with an oven and a cooktop.

Dating 6 years

If the range is new it should be wired for a 4-prong cord; this follows a National Electrical Code requirement that was initiated in This connection grounds the body of the appliance through the neutral cord wire. Repeat with the bottom half on the underside of the cord. Plug the cord into the range outlet, and test the range functions to confirm proper operation. No alteration is necessary.

List of free us dating sites

Attach the green cord wire to the ground screw on the range body. Reinstall the Cover Plate Reinstall the cover plate or shroud over the wiring cavity to complete the installation.

Online dating protocols